way too many IfIndex from Catalyst4500 with Sup8e

way too many IfIndex from Catalyst4500 with Sup8e

hello

I have configured Flexible Netflow on a Cisco Catalyst 4500 with Supervisor 8E.

also I have added SNMP credentials for the device in Netflow Analyzer, however I am getting 2430 interfaces from this device - alot with just long "IfIndex" names - this is of cause way too many interfaces, but I cant seem to get it to just show/report the actualt interfaces..

do I have to configure something special on either the Catalyst 4500 or in Netflow Analyzer ??

this is my config from the Catalyst 4500:

flow record FlowRec2
 match datalink dot1q vlan input
 match ipv4 protocol
 match ipv4 source address
 match ipv4 destination address
 match transport source-port
 match transport destination-port
 match interface input
 collect counter bytes
 collect counter packets
 collect timestamp sys-uptime first
 collect timestamp sys-uptime last
!
!
flow exporter FlowExp1
 destination 10.1.10.95
 transport udp 9996
!
!
flow monitor FlowMon2
 exporter FlowExp1
 cache timeout inactive 30
 cache timeout active 60
 cache entries 1000
 record FlowRec2
!
interface GigabitEthernet2/1
 ip flow monitor FlowMon2 input

              New to ADManager Plus?

                New to ADSelfService Plus?