Fortigate 100 D Configuration

Fortigate 100 D Configuration

Dear Support Team,
I have recently purchased Fortigate 100 D Firewall. Before I had Juniper firewall which was fully compatible with Manage Engine. Please provide a setup guide how to configure log in Fortigate device so I can see the traffic. I had gone through the below mentioned steps but in the manageengine it shows unparsed record.
  • Execute the following commands to enable Syslog:

Enable syslog:

config log syslogd setting<cr>

set server (ip address)<cr>

set status enable<cr>

end<cr>

  • Execute the following commands to enable Traffic:

Enable traffic:

config log syslogd filter<cr>

set severity information<cr>

set traffic enable<cr>

set web enable<cr>

set email enable<cr>

set attack enable<cr>

set im enable<cr>

set virus enable<cr>

end <cr>


Regards.



              New to ADManager Plus?

                New to ADSelfService Plus?